كاميرات من نوع اس ، اکس ۷۰ ، ٣-a .. كتاب التصوير للهواة

Then move the camera back and forth a little until you see the object through the lens in the clearest and most uniform way possible. The telephoto lens, which is mounted above the camera lens, enables you to capture objects 13 cm away from the camera in the natural size of the points from the pictures.

time exposures:

In low light, the SX70 can do an automatic exposure of up to 14 seconds. To get the best results inside, the view must be reasonably and evenly lit. A bright light or a window in the view can fool the electric eye into making the main body too dark. Place the camera on a tripod or other stabilizing device. Polaroid's remote shutter button #112 helps prevent the camera from moving. Press the shutter button and do not lift your finger until the picture comes out of the exit hole and all camera sounds stop, it may take 16 seconds. The exposure camera must be saved, otherwise the image will be blurred. stationary during

Keep the acid rollers clean:

Check the reels inside the film door before packing it. Dirty rollers make the image development uneven and lead to frequent spots appearing in the image. To prevent dust from entering the film chamber, leave an empty tray in the camera
while you are cleaning the rollers. While the film door is open, press the shutter. To expose the rollers, rotate both rollers and remove any particles or dust from them with a clean cloth dampened with water if necessary. Take special care of the raised edges on the upper pulley as dirt may collect near them. The image exit slit can be cleaned by inserting a piece of hard paper (such as film removed from a new film canister) in front of the rollers and under the visor.

Push the tray until it is out of the image exit slot and slide it into the slot to remove any acid build-up chemicals that may be trapped there, do not use force to open the image exit slot

Image problems and their causes:

A - Part of the image is missing: the chemical chamber in the film unit may have been damaged before the film passed through the camera rollers, and developing chemicals may have seeped into the rollers, the image exit slot and the image backing, clean the rollers and the image exit slot

2- Hazy film: The presence of white areas in the image indicates that the film has become hazy before exposing it to the camera. Taking out the film canister and inserting it again into the light may cause this. If it is necessary to remove the film canister from the camera, then

The first piece of film will always be blurry, and the following images may be blurred in one corner. And if it is necessary for you to take out a partially used film box, do so in the light. faint

2- A blurred image (unclear): it is possible to obtain images with a haze if they were taken in low light or by using a flash and the camera or the part to be photographed moved during the exposure. Hold the camera steady from the moment you press the shutter button until the photo exits the camera.

Camera problems and their solutions:

-1

If the camera does not throw the film or the film itself:

When you enter a new film box and close the door or when you press the shutter button, you find that the camera motor makes a sound and the film film or part of the film comes out. If he does not do either of these two, then the battery in the film canister is dead. Try another film and put a new battery. on him

If the camera does not throw the cover film or the film despite you hearing the sound of the motor, the defect may be in the camera or in the film case, but not in the battery. Check it by inserting another film tray. If the film cover does not come out of the second box, the camera is in need of repair

If the shot becomes black as long as you press the shutter button without the image coming out, this means that monitoring the internal battery of the camera indicates that your battery is too weak to take any picture.

Insert a new film tray and replace the battery.

Reminder:

The camera does not work if the five lights on the front-facing side of the flash unit are all used. If the camera does not work when the front-facing side lights of the flashers are unused, rotate the flash to another side or install a new unit. If you can take a picture then one side of the flashes was not working. this means

If the camera stops during a cycle:

This is either because you release the shutter button too quickly instead of pressing it until the picture comes out, or because the battery in the film case is weak or dead. First press the shutter button again and hold. If the camera does not complete its cycle, open the film door in dim light and pull the film tray outward by a distance of 3 cm. Push the film canister back in and close the film door (the photo counter will return to 10) and the camera should complete its cycle and remove the top piece of film. And if it didn't work
After all that, the camera's battery is likely to be empty. Remove the cassette and insert a new cassette or an empty cassette - most empty cassettes hold backup current and the camera should complete its cycle. (If you insert a new box of film, you risk losing a piece or two of the film.)

01

As you insert a new can, the film cover may pop out

The door cannot be closed:

Slide the film cover and close the door. If you can close the door, but only with part of the film cover coming out, open the door again and move the film cover forward by turning the rollers. Never try to force the cover through the rollers before opening the film door first. Do not attempt to close the camera if it is in position, as this may damage the internal movement device. To store the camera temporarily or ship it elsewhere, you can fold it to the point where you feel little resistance. And don't push it any further. half a turn

Caring for the SX-70:

Camera :

Usage not. Use the camera carefully, keep it closed in case, keep the lens and viewfinder clean, and avoid leaving fingerprints on it.
the film :

Keep it in a cool place Keep the film and the camera loaded with film away from direct sunlight and away from places where temperatures may rise such as glove compartments and bags in cars in warm weather Do not break the seal (cap) on the film canister until you are ready to use the film

the pictures :

The SX-70's images are among the most stable and anti-tarnish in the art of photography. These pictures have an unusually long life, but you should avoid folding or bending them. The completed picture is confined within its frame on a glossy white base that gives bright brightness to the picture and there is no waste to be disposed of.

Do not cut or trim the edges of the photo as this damages its shape. You can easily remove fingerprints from your photos by steaming the surface of the photo by breathing on it and then buffing it with a soft tissue paper or a clean soft cloth

Electronic flash:

Some electronic flash units may work well with the camera. Others may not be suitable for the camera for several reasons, causing inappropriate results for the images or even damaging the camera.