الطبع والتكبير .. كتاب التصوير للهواة

Printing and enlargement Setting up the printing machine and the settings of the work and the settings on the required zoom degree and the film is entered into the film and manage the light control button on the red light and press the image on the sensitive paper on the mounted painting until the picture is cleared on the sensitive sheet The light control light on the white light and there is no printed on the paper and then the sensitive paper is taken and placed in the arena acid and then appears normal and after the show is washed with water well and then placed in the installer for from 10 to 15 minutes and then placed in a machine Filtering to dry, including to polishing and there is a printed image in the right way Notes: 1. Animals must be placed at a temperature of 15 to 20. 2 - The film must be held from the parties and not from the middle and must be saved in a clean and cool place. 3 - When printing, the use of the red light is when the image is adjusted on the sensitive paper

- All printing and enlargement operations are done in the dark and with the use of

The red searchlight located within the contents of the box for the machine. And not to mix them e - A basin should be allocated for each type of acid

With some, there is no reaction or damage to the basins because they are made

of plastic material

The towel must be used when using any acid to dry the hands with it

.

The purposes for which the machine is used are:

Print single-row and multi-row panorama images. B - Printing and enlarging the individual photos in degrees of enlargement

different lenses

When the device is set to 2.5, it gives an image of 6×9.

Care and maintenance of the printing and enlarging machine:

1- Care must be taken to store and use them properly. 2 - When turning on the light it is necessary to remember to convert from

The lowest temperature to the highest should be covered with water (the surface of the lenses), but it must dry and it is necessary to wait for it to dry.

- Light diffusion lenses must heat up at some distance or they will go bad

Machine wires must be in good condition to avoid short circuit or fire:

e- After work, the machine must be tested and cleaned.

Steps to work with imaging tools:

After exposing the sensitive film to light, it will have an image of the thing, but it is not visible at all, and in order to make this image appear, the film must appear. Therefore, the process of showing the film transforms the image from invisible to visible, with the help of the acid of appearance. Show the image, then wash the image, then carry out the installation process, then wash it again, then dry the film.